Wednesday 15 February, 2017 | RSS Feed

How to programming EEPROM via digiprog 3 mileage correction tool

by OBD2cartool.com

How to programming EEPROM via digiprog 3 mileage correction tool?


Digiprog 3 is the most popular Odometer correction tool, Latest V4.94 Digiprog 3 Mileage programmer add more car models on the basic of V4.88 Digiprog III odomaster correct tool.

HQ digiprog 3 odomaster correct tool full set

But do you know how to program EEPROM with digiprog 3 odometer correction tool through “EEPROM”
menu. there obd2cartool.com will help you to know:


EEPROM programming with Digiprog 3 is done through some adapters, for example, 01/04 Adapter,Digiprog 3 ST02 cable or others. These adapters can be purchased at local aftermarket shops or from online stores.


EEPROM chip 01/04 Adapter picture taken:

digiprog 3 01-04 adapter
Notes before you start:
1. De-solder eeprom
2. Make sure the contact points or legs with glass fiber pin thoroughly.
3. Clean clearly with sandpaper, etc
4. Insert eeprom correctly into Digiprog3 ST01/ST04 adapter, and make sure they are contacting.

 

How to programming EEPROM via digiprog 3 mileage correction tool?
1. Connect DP3 device to your car via OBD connector
2. Enter “EEPROM” menu

digiprog iii program EEPROM
3. Read data from EEPROM and store them in digiprog3 Follow this way:
Select the “SET TYPE” and choose “93C46″, then your digiprog has been set up to read a 93C46 chip. Press “EEPROM” again and then “READ”. There will show you the information on the digiprog III screen when the reading is complete. Now press “VERIFY” so the information on your screen can agree with the Eeprom.
Next click the “FILE” and there will show you another submenu, you can click “SAVE” and enter a file name for the information you are saving. Once you entered the file name, your data is safe and the vehicle is now ready to be reprogrammed.
4. Get EEPROM from ST01/ST04 adapter and reload it;
5. Select the function EEPROM COMPARE;
6. Then it is the previous read data on digiprog 3 but not the internal memory, comparing it with the now re-inserted EEPROM;

 

NOTE:
Error message may appear during the process, restore or reprogram, restore the original data status and it will be
fixed.
External eeprom programmer Read and store data status Take EEPROM from the adapter and insert it again
Re-read data level and save it
Comparison on data sets in the editor (windows—total commander)
If the comparison is identical, it is correct.
If the data is restored already, the reprogramming error shows the original data
Data state produced!






News for Wednesday 08 February, 2017


View all news for Wednesday 08 February, 2017 on one page




Recent News




News archive

  • Online Tracking Packages

    All packages have online tracking number
  • Customer Protection

    100% Full Refund if you don't receive your parcel
  • Available Payment Term

    PayPal, Visa/MasterCard, Western Union, Bank Transfer...
  • Service Guarantee

    Free Technical support, One year warranty