Wellon VP-596 programmer is ZIF 48Pin Universal Programmer, Wellon VP-596 supports over 34,000 devices, including PIC microcontrollers, EEPROMs, dsPIC, AVR and other microcontrollers like AT89, plus PLDs and Flash memory.
Electrical spec. of the AC adapter: AC input 100V to 240V, 50/60Hz, DC output 9V/2.0A; power:18W
PLD: CPLD, EPLD, GAL,PEEL,PALCE and more
The programmer is designed using state-of-art hardware architecture with on-board high-speed CPU, RTOS, FPGA, CPLD and high-quality universal pin-drivers. The universal pin-drivers can route programmable precision voltage signals, GND and CLK to any pin. An FPGA provides full I/O signals (level programmable from 1.5V to 5V) to up to 48 pins. This makes the programmer truly universal: Both current and future 5V and low-voltage devices are supported. Different devices in the same package share one adapter. For example, the only QFP44 adapter (WL-TQFP44-U1) supports all MCUs, PLDs and memory. All DIL devices are supported directly with the standard ZIF48 socket.
Manufacturer-approved algorithms, precision and clean signals promise high programming yield. Algorithm waveform is generated by hardware offering 0.01V programming voltage resolution and 1-microsecond timing resolution. Special design was made to eliminate overshoot and ground bounce. Algorithms are performed with state-machine architecture constructed with an FPGA to achieve an ultra-high programming speed.
Insertion and continuity check are performed before programming to protect devices from damage due to operator error. Over-current and over-voltage protection is enacted to each pin to protect the programmer hardware from damage due to bad chip short circuit and ESD.
The included WL-ISP-U1 in-system programming adapter's 10 flying leads are all labeled, so you can be sure that you're putting the correct wire on the correct pin when you need to program your devices in circuit.