Remote Flip Key 3 Button 433MHZ for Focus,with Transponder chip 4D-63. Remote Flip Key 3 Button case shell for Focus to replace the old or damaged key shell. Remote Flip Key 3 Button ABS case for Focus ABS paint shell can be used to protect and beautify your remote control key.

Focus Remote Flip Key 3 Button 433MHZ Focus key case shell

optional 1:
Remote Flip Key 3 Button 433MHZ for Focus

Transponder chip 4D-63
Remote Frequency: 433mhz

Fit For:
2008-2013 Fiesta
2004-2012 Focus
2003-2012 C-Max
2006-2010 Galaxy
2008-2010 Kuga
2003-2010 S-Max
2003-2010 C-Max
2007-2011 Mondeo MK4

Please ensure your current remote key shell looks exactly the same as the shell in the picture

Packing List:

1pc x Remote Flip Key 3 Button 433MHZ for Focus

FAQ:

Q: It is key with electronics?
A: Yes, it is key with electronics.

optional 2:

Remote Flip Key 3 Button case shell for Focus to replace the old or damaged key shell,not with chip.

5pcs X Remote Flip Key 3 Button case shell for Focus

optional 3:

 Remote Flip Key 3 Button ABS case for Focus ABS paint shell can be used to protect and beautify your remote control key.

5pcs X Remote Flip Key 3 Button ABS case for Focus key

Note:
To program the remotes you will need to have all the remotes available for the car as you need to relearn them all.
To program the key you will need to have 2 keys available for the car.

Step 1
Sit in the car with the doors closed
Turn the ignition to the ACC postition and press the rear demist button 3 times, within 5 seconds.
You then press a button on the first remote to be trained , the door locks will cycle.
Then press a button on the 2nd to be trained and the door locks will cycle again.
Repeat this step for the the rest of the remotes to be trained to the car.
The first keypad trained will result in one door lock cycle, the second will result in 2 door lock cycles, and so on.
There is a limit of 8 remotes per car.
Turn the ignition to the OFF position to exit the learning mode.
Your remotes are now programmed to your car.

Step 2
You will need to have 2 orginial keys available if you wish to train a new key follow the elow instuctions.
If you only have 1 working key it will need to be programmed by dealer or locksmith (the procedure listed below will not work)
ensure you have all keys present during recoding as any key not present will be removed from the memory.
Sit is the drivers seat with doors closed
Put the first coded key into the ignition & turn to the ACC position.
Turn this key to the OFF postition & remove the key.
Within 5 seconds put the 2nd coded key into the ignition & turn this key to the ON postition.
Turn this key back to the OFF postition and remove the key.
The door locks will then cylcle to indicate that the learning mode is active.
Within 5 seconds put the new 3rd or new key into the ignition & turn to the ON postition.
The door locks will cycle 3 times to indicate the 3rd key has been trained , ensure you wait for the locks to finish cycling before turning the key to the OFF position.
Repeat this step for any following keys , The 4th key trained will cycle the locks 4 times, and so on. you can train up to a maximum of 8 keys.
your new key should now be coded to your car